• This product is available as a download to the following member(s): "PREMIUM". Download this product by becoming a member today and also get access to over "18,209+" PLR products.

How To Make Your Car Run On Water Plr Ebook

How To Make Your Car Run On Water Plr Ebook
License Type: Private Label Rights
File Size: 444 KB
File Type: ZIP
SKU: 1879
Shipping: Online Download
Members Download

Ebook Sample Content Preview:

In order for you to have your water operated car work properly, you are going to have to have a control circuit as well as a throttle control sensor. The control circuit is one of the most important parts of putting together your water powered car.

You can go to auto repair stores, Radio Shack or any other store that sells equipment to build a control circuit. You will want to build a circuit that has a transistor which will work on 1-5 amps. You will need to buy an enclosure box for the circuit system as well as a circuit board, IC sockets and other parts for the circuits. This is the electrical control panel of the car and will need to have room for the three gauges that you are going to install in the system. The gauges will connect to the reaction chamber which will actually turn your water in the tank into hydrogen and oxygen and enable the car to have power.

If you have never before built a control circuit before, have no fear. You can usually get diagrams on how to do this when you buy a kit. You can go with a kit that enables you to build a circuit board such as those offered by DigiKey.

This is a small system that you are making so you do not have to worry about building a big control circuit. The purpose of the control circuit is to send signals to the rest of the car to basically run. This will be pretty much the brains of the car. The control circuit will override the other circuits you have in your car.

When you are building a car that runs on water, you do not want to take apart the car so that it does not run on gasoline . The methods that are outlined in this book are meant to enhance the car so that it runs on water that is basically turned into hydrogen. You do not have to rebuild the engine or any parts of the car. The control circuit, therefore, will override the current controls that you have on your car and enable it to run on water.

You are going to want to watch the electrodes on a oscilloscope when you are using the car. The control circuit that you build will have to send a signal to the reaction chamber (which you will also build) so that the engine gets fired up and the hydrogen oxygen injects into the system and becomes a fuel.

An oscilloscope is a product that can be purchased at either an auto parts store, an online store or at an electronics store. You are going to have to make sure that you have this device attached to the gauge so that you can read what is going on with the control circuit. The control circuit will give off a square pulse signal and can be observed on the oscilloscope. This way, you will be able to see the pulses that are in the reacting chamber that are making your vehicle run.

The faster you want to go when you are driving your water operated car, the more pulses you will want to make in the reaction chamber. This will be determined by the throttle control which is part of the control circuit system.