• This product is available as a download to the following member(s): "PREMIUM". Download this product by becoming a member today and also get access to over "18,209+" PLR products.

What Shall We Do Give Away Rights Ebook

What Shall We Do Give Away Rights Ebook
License Type: Giveaway Rights
File Size: 5,040 KB
File Type: ZIP
SKU: 16313
Shipping: Online Download
Members Download

Ebook Sample Content Preview:

A cardboard house, furnished with paper furniture and occupied by paper dolls, is a very good substitute for an ordinary dolls' house, and the making of it is hardly less interesting. The simplest way to make a cardboard house is to cut it all (with the exception of the partition and the roof) in one piece.

The plan given here is for a two-roomed cottage, the measurements for which can be multiplied to whatever size you like (or whatever is the utmost that your sheet of cardboard will permit). The actual model from which this plan was made (the house was built from a royal sheet of Bristol board) had a total floor measurement of 8 inches by 14. The end walls were 5 inches high, the side walls 5 inches, sloping up to 7 in the middle, and the partition was 7 inches. The roof was slightly wider than the floor, in order to make wide eaves, and as much longer as was needful not only for the eaves but also to allow for the angle.

The first thing to do is to rule the outline of the cottage. All the measurements must be most accurately made, as the slightest incorrectness will keep the house from fitting together properly. Then cut it out. When this is done, draw the windows and doors. Then lay your cardboard on a board, and run your knife along each side of the windows and the three free sides of the doors until the card is cut through. A ruler held close to the penciled line will make your knife cut straight. The bars across the windows can be made of strips of paper glued on afterward. If the doors have a tiny piece shaved off each of the cut sides, they will open and shut easily.

To make the front door open well, outward, the hinge line of the door (KK) should be half cut through on the inside. The hinge can be strengthened by gluing a narrow strip of paper or linen along it. At the three points marked H make small slits through which to put the tags, marked G, of the partition wall.

All drawing and painting must be done on both sides while the house is still flat. The doors inside will need handles and keyholes. Small pieces of mica can be glued over the windows instead of glass.

Little curtains of crinkly tissue-paper can also be made, and, if you like, the walls can easily be papered with colored paper pasted on. This will cause some delay, however, for it must be well pressed. Instead, wall-paper patterns could be painted on.

Outside—that is, on the underside of the cardboard—there is a great deal to do. Both walls and roof can be painted, and tiles, bricks, and creepers imitated. The front door should have a knocker and a letterbox, and around both the door and the windows should be imitation framework. As the upright joints of the four walls will be made of linen painted to imitate brick-work or stone-work, you need not carry the painting of the walls quite to the edges, because these will be covered by the joints. It is best to paint the joints before you stick them on.